2011 BMW 3 Series: what the MOT records show

BMW 3 Series cars first used in 2011, from 25,224 MOT tests in 2025. Data to December 2025. Updated 16 November 2026.

In short

These figures cover every 2011 BMW 3 Series tested. They don’t tell you about the one you’re looking at, which has its own MOT history.

What stands out

Compared with all cars first used in 2011, in 2025 MOTs. Only differences bigger than the margin of error are listed.

Pass rate at the first attempt

2011 BMW 3 SeriesAll cars first used in 2011
Passed first time69%61%
Tests25,2241,506,535

How we count: normal MOT tests only, not retests. A car that failed but was fixed and passed at the test station within the same visit (“pass after rectification”) is counted as a fail, the same rule on every page.

Most common reasons for failing

Share of first-attempt tests in 2025 that failed on at least one item in each area.

Area2011 BMW 3 SeriesAll cars first used in 2011
Lamps, reflectors and electrical equipment13%17%
Suspension9.8%15.7%
Tyres8.1%7.2%
Brakes7.2%9.0%
Visibility3.9%5.4%

A test can fail on more than one area, so these don’t add up to the overall fail rate.

Most common advisories

Advisories are things the tester noticed that weren’t bad enough to fail, but may need attention soon. Share of first-attempt tests with at least one advisory in each area.

Area2011 BMW 3 SeriesAll cars first used in 2011
Tyres29%29%
Suspension27%31%
Brakes22%26%
Noise, emissions and leaks11.1%10.0%
Body, chassis and structure6.0%7.0%

DVSA’s advisories that aren’t tied to one area of the car aren’t shown. What MOT advisories mean.

Advisories that became fails

When a 2011 3 Series had an advisory in one of these areas, how often did it fail in the same area at its next MOT? Compared with all cars first used in 2011.

Advisory area2011 BMW 3 SeriesAll cars first used in 2011Cases
Tyres11%10%6,840
Suspension15%20%5,704
Brakes11%13%5,179

Pairs of consecutive normal tests on the same car, across 2024–2025. An area is shown only with at least 300 cases. If the car you’re viewing has an advisory in one of these areas at its last MOT, ask whether it’s been fixed and for the receipt.

Dangerous defects

9.8% of first-attempt tests found at least one dangerous defect, against 9.8% for all cars first used in 2011. A car with a dangerous defect shouldn’t be driven until it’s fixed.

Mileage

2011 BMW 3 Series
Typical (median) reading at 2025 MOTs121,028 miles
Middle half of cars93,750 to 149,541 miles
Typical miles a year, between MOTs5,903 miles

Miles a year from 23,039 cars with two MOT readings at least 180 days apart.

A car well above or below the typical figure isn’t a problem in itself. What matters is that its own readings go up steadily, and that the service history agrees.

Readings that went down

For 0.2% of the 23,329 2011 3 Series cars with two or more MOT readings in 2024–2025, a later reading was lower than an earlier one by more than 1,000 miles. For all cars first used in 2011 it was 0.2%.

This can be a typing slip at the test, a replaced instrument cluster, or a reading taken in kilometres. It isn’t proof of clocking. If the car you’re looking at has a reading that goes down, ask the seller why and look for paperwork that explains it.

How to spot a clocked car

Fuel and engine

Share of 2011 3 Series cars tested in 2025
Petrol25%
Diesel75%
Over 1,400cc100%
Electric, or engine size not recorded0.1%

At the viewing

Based on the most common failures and advisories above.

Light faults are often a cheap fix, but they're easy to miss. At the viewing, ask the seller to switch on each light in turn while you walk round: dipped and main beam, indicators, brake lights, fog lights and the number plate light. A warning light on the dashboard that stays on is worth asking about.

Drive over a few bumps at low speed with the radio off. Knocks, clonks or a car that keeps bouncing after a bump are worth asking about. Look at whether the car sits level when parked.

Look at all four tyres, and the spare if there is one. The legal minimum tread for a car is 1.6mm across the central three-quarters of the tyre, all the way round. Uneven wear, for example on the inside edge only, can point to alignment or suspension problems. Check for cuts and bulges on the sidewalls.

On the test drive, brake firmly on a quiet straight road. The car should stop in a straight line without pulling to one side, juddering or grinding. Check the handbrake holds the car on a slope. Ask when the pads and discs were last replaced and whether there's a receipt.

Then ask the questions any seller should be able to answer: how long they’ve had it, why they’re selling, whether there’s a service history, and whether they have the V5C logbook in their name at this address.

Questions to ask a private seller

About this data

Source: DVSA anonymised MOT tests and results, 2024–2025, Great Britain. Cars (test class 4). “2011” means first used in 2011, which can differ from the model year. Figures are for cars that had an MOT, so cars kept off the road aren’t counted. MOT data doesn’t cover repairs between tests, servicing, accidents, finance or write-offs. DVSA’s records don’t say which version or generation of a model was tested, so a year can include more than one version of the car.

Figures produced by Checks from DVSA data, using the method at how we work out our MOT figures. This page is generated automatically from those figures; the wording around them was written and is checked by the Checks team.

Contains public sector information licensed under the Open Government Licence v3.0.

Data to December 2025. Updated 16 November 2026.

2009 BMW 3 Series MOT records · 2010 BMW 3 Series MOT records · 2012 BMW 3 Series MOT records · 2013 BMW 3 Series MOT records · BMW 3 Series MOT records by year · All BMW models · How to read an MOT history